LS63

LS63

Telescopic Aerial Device

Designed for lighting and sign maintenance, this non-insulating unit is built to be a man-lift aerial, but has versatile lifting capabilities. The 600 pound capacity platform can remain attached or remove in seconds for load line operation of up to 5,900 pounds, which could potentially reduce the amount of equipment needed at your job site. Built with standard platform rotation and a 57 foot working side reach, this truck makes it easy for your crew to set up at a busy job site while taking up a smaller working footprint.

Request a Quote
General Specifications:
Ground to Bottom of Platform*: 58.8 ft (17.9 m)
Maximum Side Reach: 56.9 ft (17.3 m)
Boom Articulation (Lower Boom): -20 to 80°
Rotation: Continuous
Download Spec Sheet
Standard Features:
  • Aerial Operation ANSI 92.2 Compliant
  • Crane Operation ASME B30.5 Compliant
  • Three-stage hydraulically sequenced telescopic boom (non-insulating)
  • Continuous rotation
  • Hydraulic self-leveling platform
  • 60 x 40 in (1524 x 1016 mm) steel platform with 90 deg of rotation
  • 600 lb (272 kg) platform capacity
  • Platform quick disconnect
  • Hydraulic Overload Protection system (HOP)
  • Multi-handle proportional controller
  • Outriggers: Primary rear out-and-down; Auxiliary front A-Frame
  • Engine start/stop
  • Emergency power
  • Emergency stop at control stations
  • Boom angle indicator
  • Outrigger motion alarm
  • Back up alarm
  • Truck level indicators
Optional Features:
  • Auxiliary front out-and-down outriggers
  • Single-handle proportional controller
  • Material Handling Attachment
  • Outrigger short jacking system with rotational interlocks
  • 5900 lb (2679 kg) primary winch with 58 ft (17.7m) max sheave height and anti-two block switch
  • 2,000 lb (908kg) Primary Winch with 58 ft (17.7 m) max sheave height and anti-two block switch
  • Primary winch tensioning device
  • 500 lb (227 kg) platform jib winch
  • Platform material extensions
  • Radio Remote for Crane Operation
  • Weld leads at platform
  • Cab guard
  • Welder/generator with remote start/stop
  • 110V power source at the platform
  • Platform or line body configurations
  • Tow packages
  • Auxiliary boxes for storage
Recommended Features:
  • Wheel chocks
  • Outrigger pads
  • Fall protection system

*Based on chassis frame height of 40 inches (1016 mm)

Altec Aerial Devices meet or exceed all applicable ANSI Standards as of the date of manufacture. Altec reserves the right to improve models and change specifications without notice or obligation. Altec provides custom options in countries throughout the world. Please contact Altec Worldwide for the options available in your country.